ERGO cladding photo gallery
With our facades made of AMK (acrylic marble crumb), facade decorative elements made of expanded polystyrene look great. They give the facade a finished look and shape, and the house style and status!
About ERGO decorative coating
Only high-quality and environmentally friendly raw materials are used in the production of ERGO. The coating itself is ready-made sheets of 1.05 m2, which are easily mounted on a wall made of aerated concrete, concrete, plasterboard, without insulation, with insulation with expanded polystyrene or hard mineral wool with the help of glue.
The "feature" of the facing is in the protective film, which is on every ERGO element. Thanks to this, installation is quick and with minimal labor costs, even an untrained person can master it. ERGO coating does not bear the load on the structure, can be installed even on ceiling structures and is much cheaper than many finishing materials.
In the production of ERGO, fine marble crumb is used, it gives the material a natural appearance and looks like real stone masonry. The color of the marble crumb is produced by iron oxide pigments, which makes the coating resistant to ultraviolet light and bad weather and does not require periodic painting, like a decorative plaster coating. The ERGO facade does not lose its color over time. Therefore, it is possible to use ERGO decorative cladding both for facades and interiors.
Advantages of ERGO facades
Why you should pay attention to this cladding:
.png)
Composition of natural components
It is made of natural marble chips.
.png)
Installation on any surface
Mounted on CSP, aerated concrete, foam concrete, expanded polystyrene, foam plastic, hard mineral wool, plasterboard, plaster.
.png)
Vapor permeability
AMC cladding allows the walls to "breathe".
.png)
Dirt is easily removed
The cladding is easily cleaned with water and does not accumulate dust and dirt.
.png)
No installation skills required
Even an untrained person can master installation.
.png)
Fire resistance
Thanks to the stone composition, it is not afraid of fire.
.png)
Aesthetic appearance
AMK finish has many color options and their combinations. It can be mounted both on the facade and in the interior.
.png)
Fast installation
The presence of a special protective film speeds up installation by 2 times compared to analogues.
.png)
Resistant to environmental influences
It is not afraid of moisture, polluted air, does not burn out in the sun.
.png)
Repairability
Easy replacement of each individual brick without replacing the entire sheet.
.png)
Light weight
The system does not load the walls and allows you to attach it even to plasterboard partitions.
.png)
Saving money
AMC cladding is on average 20-30% cheaper to install and operate than similar types of finishing.
Installation of the ERGO facade
Installation sequence:
1
Surface preparation and priming
2
Marking and preparation of adhesive solution
3
Applying an even layer of glue to the surface
4
Apply and smooth the facing sheet until the glue penetrates through the seams
5
Fill the seams with glue
6
Remove the protective film and wait for complete drying within 48 hours
Video instructions for installing the system
Selection of glue for installation
-
White glue for mosaic and ceramic granite
-
Moisture resistant
-
Adhesion to concrete, solution - not less than 1.0 mPa
-
Atmospheric resistance - not less than 1.0 mPa after 25 cycles
-
Operating temperature - from +5 to +30 °C
-
Operating temperature - from -50 ° to +70 C.
ERGO customer reviews
CONTACTS
Phone:+380979278051
Address: Kharkov region, Travneve, vul. Fabrychna 12
e-mail: info@mysite.com
.png){kind=small}
.png){kind=small}